Get a quote
Block paving half cleaned, with a rotary surface cleaner resting on the clean section

Oil and fuel removal, re-sanding

Car park and block paving cleaning

We clean car parks, block paving, service yards and walkways, treat oil and fuel stains, and re-sand block paving joints afterwards so the surface stays firm.

What we do

Clean, treated and re-sanded

A rotary surface cleaner cleans the paving under a hood, which controls the spray and gives an even finish without stripes.

Oil and fuel stains are treated separately. Fresh spills often come out fully. Old stains that have soaked into the surface usually fade a lot but may not disappear, and we tell you that before you book.

Cleaning washes sand out of block paving joints, so we re-sand with kiln-dried sand afterwards. That keeps the blocks locked together and slows weed growth.

  • Weeds and moss taken out of the joints
  • Kiln-dried sand brushed back into the joints
  • Wash water kept out of surface drains
A rotary surface cleaner on wet block paving, with its hose running back across the paving

How a job runs

The same four steps on every site.

1

Tell us about the site

Use the quote form: the site, the work and any time limits. Photos and plans help.

2

We price it

From a site visit or your photos and plans. You get a written price for the agreed scope.

3

We plan and send RAMS

Dates set around your trading hours, with the risk assessment and method statement for your site.

4

Work done, then reported

A vetted team does the work and you get a report with before and after photos.

Get my quote

Questions managers ask

Car park and block paving cleaning: questions answered

Price, timing, disruption, out-of-hours work, proof and insurance.

How much does car park cleaning cost?

The main price drivers are the area in square metres, the surface (tarmac, concrete or block paving), how many oil stains need treating, whether block paving needs re-sanding, and whether the work has to be done at night. We price from a site visit or a plan with measurements.

How long does it take?

It depends on the size and the surface. We split larger car parks into zones and tell you how many shifts each zone takes, so you can plan bay closures in advance.

Do we have to close the car park?

No. We work bay by bay or zone by zone and cone off only the area we are working in. Very busy sites are usually done overnight or early on a Sunday.

Can you remove oil and fuel stains?

Yes, we treat them as a separate step. Fresh spills often come out fully. Old stains that have soaked in usually fade but may not go completely, and we say so before you book rather than after.

Why does block paving need re-sanding?

The sand in the joints holds the blocks in place. Cleaning washes some of it out, and weeds take the rest. Brushing kiln-dried sand back in keeps the paving firm and makes it harder for weeds to return.

Where does the dirty water go?

Wash water must not run into surface water drains, which often lead straight to rivers and streams. We plan how the water is collected or directed before work starts, and it is written into the method statement.

How do we know it was done?

You get a report after each visit with before and after photos, the zones completed, stains treated and anything left to finish, with a return date.

Are you insured for this work?

Yes. We send our insurance certificates with your quote. Every subcontractor on your site must show us their own insurance before they start.

A cleaner at the foot of a tall rendered wall, working a long water-fed pole up the face

Tell us about your site

Send the site, the work and any time limits. We reply with next steps, usually within one working day.

Get my quote
  • UK-wide
  • RAMS before work starts
  • Photo report after every visit